Link Plumbing And Gas Service

Hot Water is our speciality. With over 30 years’ experience, we install and service all types of hot water systems including electric, gas for both domestic and commercial.

MISSION STATEMENT
To provide quality workmanship and a welcoming environment, where we continuously exceed the increasing expectations of our customers.

Link Plumbing and Gas Service is a WA owned and run plumbing company that has been servicing the Perth metropolitan area for over 30 years.

Link Plumbing and Gas Service specialises in the servicing, repairs and installing of all types of hot water systems.

We also provide Plumbing and Gas Services to residential homes, government departments and commercial entities.

We have a team of qualified Plumbers and Gas Fitters who provide a wealth of knowledge and experience in all facets of Plumbing and Gas Fitting.

We pride ourselves on providing excellence service, quality plumbing and gas fitting, friendly and knowledgeable staff and competitive prices.

Link Plumbing and Gas Service is a long serving member of the Master Plumbers Association.

Plumbing Services
Our qualified Plumbers and Gas Fitters offer services including:

Water leaks and burst pipes
Dripping taps
Leaking toilets
Water hammer (noisy pipes)
Cistern and toilet installation
Installation of new tapware
Dishwasher installation
Water filters
Washing Machine installation
Fridges (with in-built chillers/icemakers)
Plumbing servicing and safety checks

Gas Fitting
Our qualified Plumbers and Gas Fitters offer services including:

Service, repairs and installation of all type of Hot Water Systems
Gas leak detection
Service, repairs and installation of Gas Hobs or Cook tops
Service, repairs and installation of Gas Ovens
Installation of gas bayonet points
Installation of boiling water units
Run gas pipe extension to outside BBQs
Room heater service, repairs and installation
Setting up new gas services to homes

Backflow Prevention
Backflow refers to the reverse flow of water in a supply pipe.  The most likely cause of backflow is a drop-in pressure or if there is a problem or break in the water mains.  When backflow occurs, there is the potential for hazardous substances to be mixed in with the potable water supply.  If this happens, it causes contamination and can be harmful to people’s health.

It is a requirement of WA law that backflow prevention devices need to be installed on all properties where there is a medium to high risk of contamination of drinkable water by a reverse flow of contaminants and/or chemicals.

There are three areas that backflow devices can be installed.  Firstly, at the property boundary (containment protection), secondly at a group of potential hazards (Zone protection) and thirdly at and individual hazard (individual protection).  Once the device has been installed, tested at commissioning, it was must be serviced every 12 months by a Licensed Plumber who is qualified to do the testing.  A report will then be sent to the Water Corporation as a part of the testing procedure.

NOTE:  If yearly testing does not occur, property owners will be issued with a non-compliance notice from the Water Corporation and they risk a possible fine.

To discuss your Backflow requirements, please contact the team at Link Plumbing and Gas Service.

Hot Water Systems
Link Plumbing and Gas Service are the hot water specialists. We have been installing all types of hot water units across the metropolitan area for over 30 years.

We appreciate that hot water is an essential service and can guarantee same day servicing and/or installation.

As hot water specialists, we provide quotes that are compliant with relevant standards and by laws.

We have a range of options to suit all households and budgets. One of the first decisions you will need to make when selecting a hot water unit, is the heating method. Do you require electricity, gas, solar or heat pump?